Belted Magnum Collet Resizing Die (NEW)

Description:

Innovative Technologies resizing die for all belted magnum cases. (New and in original packaging) - FREE POSTAGE

USA Manufacturer link; http://www.larrywillis.com/

From the manufacturer's website;
Belted magnum cartridges have been around for over 50 years, and most shooters that reload them are familiar with the case bulge problem that occurs "just above" the belt. This usually happens after just 2 or 3 firings - wasting perfectly good cases. Many shooters have discovered this problem when they find their handloads begin to stick in their chamber, or when they no longer chamber at all.

Unlike non-belted cases, the belt prevents conventional full length dies from travelling far enough down the case. This limits the amount of resizing, and brass is plowed rearward. The brass builds up just above the belt at each reloading, and cases expand. Neck sizing dies don't bump the shoulder back or resize the tapered case wall. The best solution is to full length resize accurately, and use this collet die to reduce case width.

Our patented Belted Magnum Collet Resizing Die solves this problem and has other unique features. The top of this die is a case width gauge that shows when a little "extra" case resizing is required. This resizing die is used to eliminate the case bulge above the belt, after using your full length (or) neck sizing die. Our collet die ensures that your belted magnum ammo will always chamber properly and your cases are now able to last for up to 20 firings, even when using the hottest handloads. Our resizing die uses a collet that fits over the cartridge case, until it bottoms against the belt. The case is then pressed into the sizing die. The collet allows your case to go farther into the die where it only reduces the area "just above" the belt.